3. Basic photography
Non-mydriatic photography
3
-2
P3-5
n
Flash intensity.
Exposure can be automatically adjusted to have a standard intensity for each
photography. But it is expected that excess or deficiency in exposure caused
by the difference in dilation, color of iris, etc. will cause some deviation
from the standard state. In case excess or deficiency in exposure should
be expected, correct the exposure by the flash intensity compensation
knob. On the display on the panel, a currently set value of exposure will be
indicated as a standard. One stage of the flash intensity compensation knob
corresponds to the change of the intensity of exposure by 1/2 EV.
n
Angle of LCD monitor.
If the monitor should be hard to watch, adjust its angle so that it comes in
front of your line of sight.
n
Working camera back indicator.
Operations of the indicating lamp show the following:
Camera selected Display Description
35-mm camera
OFF Camera back not mounted
“
2
”
FLASH
Film not loaded
2
ON Photography enabled
Electronic image
OFF Connecting adapter not fitted
1
ON Photography enabled
• 35-mm camera back.
Photography with 35-mm film in non-mydriatic mode will produce flare around the picture taken.
• Panel display.
On the panel display, only available buttons in a selected mode will be lit to prevent miss operation likely to
occur in a dark room.
Note that the button on the display, which is OFF, will not be available in the selected mode.
• Non-mydriatic photography of peripherals is liable to produce flare around the picture.
■
Flash intensity compensation
knob / display
■
Adjusting the angle of LCD
■
Working camera back indica-
tor
To Next Page
Loading...
