7. Maintenance and inspection
Maintenance and inspection
7
P7-5
7-7 Replacing fuse with a new one
1) Turn OFF the power switch before unplugging from the power outlet.
2) Turn the power unit's fuse holders by flathead screwdriver
counterclockwise to take out fuses in service.
3) Replace with new fuses and close the fuse holders. Check for their
indicated rate and type before fitting them in place.
Warning
Unplug
When replacing with new fuses, turn OFF the power switch and
unplug from the power outlet. Otherwise, there is a fear of elec-
trical shock.
Use accessory or designated fuses. If other than designated
ones should be used, there may occur failure or a fire on the
equipment.
7-8 Fitting chin rest paper
Set chin rest paper at the chin rest and fix it by pins.
For each patient, replace by a piece of fresh chin rest paper being used for a previ-
ous patient.
7-9 Replenishing consumables
Please place your orders by the ordering numbers listed right.
Caution
The fuse differs according to the voltage which is used. Make sure
to use a correct fuse when replacing it.
Consumables Ordering number
Flash lamp K9L9 FU3A
Observation lamp K9L52 A26
Data card K9L33#225
Fuse×2 0218005.MXP
Chin rest paper K9L-TB45#102
Chin rest paper pin K9L-TB45#101
Dust cover FT5#520I
2) Fuse holders
Fit chin rest paper.
To Next Page
Loading...