6.16 Stream Media: Off / Front camera / Rear camera / Front
and rear camera
6.17 G-sensor: Off / Low / Middle / High
Select to adjust the sensitivity of G-sensor. The built-in G-sensor (Gravity Sensor) will
automatically trigger emergency video recording when it detects a collision occurred, and
then lock-up the video to prevent being overwritten to retain accurate evidence for accident.
[Note:]
1) Please set the sensitivity of G-sensor to Low, so that vibrations in driving won't trigger
frequent recording and emergency locking of video to make TF card be full easily and
affect the normal working of dash cam.
2) If the car is collided when the car is turned off, the collision video can be recorded and
saved only when hard wire kit connect.
3) If the car is collided when the car is turned on, one of the car charger and the hard
wire kit power supply the dash cam, the video can automatically be recorded and
saved
6.18 Parking: On/Off
Allow to turn on or turn off the parking monitoring mode.
[Note:] Hard wire kit is needed to connect dash cam to car battery to power the dash cam
when the engine is off.
6.19 Date Watermark: On/Off
Turn on to stamp recording date and time on footage to remain accurate evidence for
accident.
6.20 Car OSD: On / Off / Modify
Input and save your car license plate number. You can choose whether to stamp it on
footage for accident reference. You can also modify the saved license plate number.
6.21 Screen Saver: Off / 1Min/ 3Min / 5Min
If select to turn off screen saver, the LCD display will always keep on. Otherwise, LCD
display will go into screensaver if there is no any operation on dash cam during the set
duration.
[Note:] Short press Power Button to light up screen while it is in screensaver status.
6.22 Front Camera Mirror: Off / On
Select to turn on front camera mirror, front camera image will be reversed left and right.
[Note:] This setting appears only when front camera is connected.
6.23 Front Camera Flip: Off / On
Select to turn on front camera flip, front camera image will be upside down.
[Note:] This setting appears only when front camera is connected.
To Next Page
