~ nn@DISPLAY␠out_id,status ␍␊
out_id - output number
status - HPD status according to signal validation (see Section 9.3 Signal Validation)
After execution, response is sent to the com port from which the Get was received
Response is sent after every change in output HPD status ON to OFF
Response is sent after every change in output HPD status OFF to ON and ALL parameters (new EDID,
etc.) are stable and valid
Command Type - System-mandatory
Reset device to factory default
configuration
This command deletes all user data from the device. The deletion can take some time.
Your device may require powering off and powering on for the changes to take effect.