Kramer VS-8UFX User Manual

Kramer Electronics Ltd.
ASPEN-32UFX, ASPEN-1616UX, VS-8UFX – Protocol 3000
54
NET-DHCP
Functions
Permission
Transparency
Set:
NET-DHCP
Administrator
Public
Get:
NET-DHCP?
End User
Public
Description
Syntax
Set:
Set DHCP mode
#NET-DHCP␠mode␍
Get:
Get DHCP mode
#NET-DHCP?␍
Response
~nn@NET-DHCP␠mode␍␊
Parameters
mode – 0 (do not use DHCP. Use the IP address set by the factory or the NET-IP command), 1 (try to use
DHCP. If unavailable, use the IP address set by the factory or the NET-IP command)
Response Triggers
Notes
Connecting Ethernet to devices with DHCP may take more time in some networks.
To connect with a randomly assigned IP by DHCP, specify the device DNS name (if available) using the
NAME command. You can also get an assigned IP by direct connection to RS-232 protocol port.
Consult your network administrator for correct settings.
Example
Enable DHCP mode, if available:
#NET-DHCP 1<CR>
NET-DNS
Functions
Permission
Transparency
Set:
-
-
-
Get:
NET-DNS?
End User
Public
Description
Syntax
Set:
-
-
Get:
Get DNS address
#NET-DNS?␍
Response
~nn@NET-DNS␠dns_id,ip␍␊
Parameters
dns_id – ID of the DNS name server to retrieve, indexing starts at “0”
Iip – IP address of the DNS server
Response Triggers
After execution, response is sent to the com port that sent the Get command.
There is no Set command.
Use NET-CONFIG to set up network, including DNS name servers.
If dns_id is out of the defined DNS range, Error Code #3 (ERR_PARAMETER_OUT_OF_RANGE) is returned.
If no dns_id is defined, Error Code #3 is returned for any dns_id.
Notes
Example
Get the DNS address for this device:
#NET-DNS?<CR>

Kramer VS-8UFX Specifications

General

Brand	Kramer
Model	VS-8UFX
Category	Network Router
Language	English