7
Above Counter Installation Instructions
Before You Begin
Prepare counter top by drilling a 1 3/4’’ diameter drain hole at the desired location. Install
mounting ring. Place vessel sink on the mounting ring or counter top as shown below.
Vessel Sink
Countertop
Mounting
Ring
Ø1 3/4”
(Suggested)
1. Make sure the vessel sink is not scratched, chipped or broken prior to installation.
2. Check to see if your set contains the following parts:
· Vessel sink
· Pop up drain (optional, may be sold separately)
· Mounting Ring (optional, may be sold separately)
3. Locate and place the mounting ring over the drain hole with the rubber side facing down and
the white washer side facing up.
4. Gently set your sink on top of the mounting ring.
To Next Page
Loading...
Need help?
General
