11
Troubleshooting
If you have followed the instructions carefully and your faucet still does not work properly, take the following corrective steps:
Leakage under the handle
Bonnet nut (12) has come loose Remove the index (14.3). Loosen set screw
(14.2) with hex wrench (14). Remove
the handle (14.1). Unscrew cap (13)
(by hand only). Tighten bonnet nut (12)
with an adjustable wrench
The water pressure
is low.
The connector underneath
the deck is clogged with debris
The aerator is clogged
Turn off the water supply and disconnect
the connector / aerator. Unscrew the
connector / aerator and clean under
running water. Screw the connector /
aerator back. Test water flow. If water
pressure is still low then replace the
connector / aerator.
Care & Maintenance
To keep the product clean & shining, follow the steps below:
1. Rinse with clean water & dry with a soft cloth
2. Do not clean with soaps, acid, polish, abrasives or harsh cleaners
3. Do not use cloth with a coarse surface
4. Unscrew the aerator and clean when necessary
This installation manual is subject to change without further notice.
The aerator has an irregular
or reduced water flow
The aerator is dirty or mis-fitted Remove the aerator and check for debris.
Ensure that the rubber washer is properly
installed.
ACID
PROBLEM CAUSE ACTION
The screen filter in the hose
connectors is dirty.
Turn off the water supply at water valve
and unscrew the hose connectors from
water supply lines. Clean the screen in the
water lines with hot water, removing any
debris or calcium build up.
To Next Page
Loading...
Need help?
General
