8
Step 5. Flushing and checking for leaks
Pull the hose assembly out of the
spout and remove the spray head
by unscrewing it from the hose in
a counterclockwise direction. Be
sure to hold the end of the hose
down into the sink and turn the
faucet on to the warm position
where it mixes hot and cold
water.
Flush the water lines for one
minute. This flushes away any
debris that could cause damage
to internal parts. Check for leaks.
Reinstall the spray head by hand
tightening it back onto the spray
hose.
1
2
NOTE:
1. Do not lose the rubber washer (1)
when installing the sprayer back on.
2. The magnet end marking with a
black dot should be toward the hose
for correct magnet installation.
To Next Page
Loading...
Need help?
General
