Thank you for purchasing Kreg components. All products have been designed to ensure safe and efficient
operation when installed and used properly. We think you will agree that our products are the best jig and
fixture system currently available. Never cut the track with your power saws. Your machine and blade are not
designed to cut aluminum.
- Woodworking machines are dangerous and can cause personal injury if not used properly.
- Read safety instructions and operating instructions for your machine completely before using products.
Using this system before understanding its safe and proper use could result in serious injury to the operator
.
- Warning: Failure to follow these rules may result in serious personal injury.
- For your own safety, read instruction manual before operating the tool. Learn the tools application and
limitations as well as the specific hazards peculiar to it.
- Keep all guards and kickback devices in proper place while using these products.
- If the standard guard must be removed, fabricate a guard to protect yourself from personal injury
.
- Never turn your saw on before clearing the area of all unneeded materials and tools.
- Always wear safety glasses.
- Keep hands well away from blade when operating saw.
- Avoid awkward hand positions, where a sudden slip could cause contact with saw blade. Never reach in back
of or around the saw with either hand to hold down the workpiece.
Beware of kickbacks; they can cause serious injury. A kickback occurs when the workpiece binds up while
being cut, causing it to twist, jump, or become airborne.
To avoid kickbacks:
- Always use sharp saw blades.
- Keep saw in proper alignment and good working condition.
- Never perform any “free hand” sawing. Work must always be held securely against the table
and fence.
- Never rip narrow or long pieces in the crosscut position.
- Always support longer boards when cutting.
- When crosscutting, pull the saw forward just enough to sever the lumber
.
Safety Guidelines
- Kreg components are fully guaranteed for one year from date of purchase.
- Kreg will replace or repair, at no charge to the customer, any product that fails within the warranty period.
- Kreg will service Kreg components beyond the warranty period at a reasonable cost to customer.
- Any neglect, misuse or usage of the Tools in a fashion not recommended by Kreg will void all warranties.
As with all machinery, there are certain hazards involved with operation and use of the machine. Using the
machine with respect and caution will considerably lessen the possibility of personal injury. However, if normal
safety precautions are overlooked or ignored, personal injury to the operator may result.
This system was designed for certain applications only. Kreg strongly recommends that this system NOT
be modified and/or used for any application other than for which it was designed. If you have any questions
relative to its application, DO NOT use the Tools until you have written Kreg Tool and we
have advised you.
To Next Page
Loading...
Need help?
General
