Kreg KMS7102 User Manual

Miter Gauge
(Revision 20060201) FT4032
The Blue Mark of Quality.
INSTRUCTIONAL MANUAL
Precision
4-
KMS7102
Note: Rockler may not carry all products and/or sizes listed in this vendor's publication
(25647)
RTD10000271AA

Kreg KMS7102 Specifications

General

Brand	Kreg
Model	KMS7102
Category	Measuring Instruments
Language	English

Summary

Safety Guidelines

General Warning

General safety warnings for operating woodworking machines.

Kickback Prevention

Hazards and prevention methods for kickbacks during cutting.

Operational Safety Precautions

Essential safety practices for operating tools to prevent injury.

Setting Up the Miter Gauge

Install T-Slot Washer

Adjust Bar to Miter Slot

How to adjust the miter gauge bar to fit the table saw slot without wiggling.

Attach Auxiliary Fence

Install Measuring Scale

Assemble Flipstop

Set the Cursor

Adjusting the cursor to accurately read measurements on the scale.

Fine-Tune Cursor Setting

Making final adjustments to the cursor for precise measurement readings.

Set Positioning Stop

Left Tilt Saw Safety Warning

Setting the Cutting Angle

Using Preset Holes for Angles

Using Scales for Angles

Explanation of how to read and use the degree and vernier scales for precise angle settings.

Set Angle Using Degree Scale

Set Angle Using Vernier Scale

Detailed guide on using the vernier scale for tenth-degree angle precision.

Resetting the Vernier Scale

Vernier Scale Realignment Procedure

Micro-Adjust Feature

How Micro-Adjust Works

Set Micro-Adjust with Feeler Gauges

Step-by-step guide to setting the micro-adjust using feeler gauges.

Set Micro-Adjust with Dial Caliper

Step-by-step guide to setting the micro-adjust using a dial caliper.