Krell Full Power Balanced X Series Power Amplifiers 17
1. When all components are linked, see How to Connect Com-
ponents Using Krell Trigger, on page 14, place each compo-
nent in the stand-by mode by moving the back panel power
breaker switch to the up position. This ensures that all compo-
nents will be synchronized when signals from the control com-
ponent are sent to the linked components in the system.
2. When the components are in stand-by, switch the control com-
ponent to the operational mode from the control component’s
front panel or by using the component’s remote control.
The linked components switch to the operational mode simulta-
neously.
KRELL TRIGGER
OPERATION
Operation,
continued
To Next Page
Loading...
