Press play (14) to begin playback of the-
programmed sequence.
Press stop (15) once to stop playback
(but not erase the program). Press stop
twice to erase the programmed
sequence.
BATTERY INSTALLATION
AND REMOVAL
NOTE: Batteries should be replaced when
functions from the remote control become
intermittent. The KAV-3OOcd remote uses
two AAA size 1.5 volt batteries.
1. Remove the back panel to expose the
batteries.
2. Remove the old batteries.
3. Install the new batteries, following the
battery position diagram on the plastic
battery receptacle.
4. Re-install the backplate.
5. Check to make sure the remote control is
functioning properly.
Page 10 of 16 KRELL KAV--300cd
To Next Page
Loading...