_________________________________________________________________________________________
Kreyer – Picture guide to installation and start-up Chilly (page 6 of 18) v.11-2015
Pic. 9: Bleeding of the pump (letting out air from the pump) – disconnect the tube/hose of the chiller
water outlet and open the outlet valve . At first the water will flow out in spurts. Keep the valve open
until the water comes out in a constant flow. This tells you that all air has been pushed out of the pump
by the water. Close the valve again and top up the water in the tank if necessary. Remember your
Glycol!
Attention:
Please check the pressure capacity of the unit pump. Please ensure that all
components in your water system are compatible with the maximum pump pressure. If
To Next Page
Loading...
