KRHÜNER 50955 - Cooling Pad Cleaning Procedure; Troubleshooting; Common Problem Solutions

chemical soluon for may cause damage to the pad.
Your device takes water from the narrow secon of the tank and pumps it on the cool-
ing pad. The water owing through the cooling pad goes down to the large secon of
the tank. The cycle results to absorpon of dust and dirt in the air which makes the air
safer and fresher to breathe. The lter, that is located at the middle poron of the tank,
cleanses the water that passes through it and should be aached to its place before using
the unit.
TROUBLESHOOTING
Problem Possible cause Soluon
1. The fan does not work 1. The power cord is not
plugged or not plugged
properly.
2. The On/O buon at
the back panel is not tur-
ned to the ON posion.
3. The ON buon on the
control panel is not ac-
vated.
1. Plug the power cord
properly.
2. Press the On/O but-
ton at the back panel to
the ON posion.
3. Press the ON buon
on the control panel.
2. The temperature of
the air being expelled is
not cold enough.
1. Dust accumulates on
the dust lter and the
cooling pad.
2. The water level in the
tank is below the “MIN”
level.
1. Follow the steps of the
cleaning secon.
2. Turn o the unit, rell
the tank with clean tap
water, turn on the power
and select the cooling
funcon.
3. The machine con-
nues working when pres-
sing the OFF buon.
If you use the heang
funcon, the machine
needs to cool down to
avoid overheang
The machine will be o in
30 seconds. Please wait.