KRHÜNER 60023 - Operation Instructions; Operating Controls; Maintenance and Cleaning; Cleaning Procedures

8. Tighten the front grill and the back grill with the plasc rim, ghten the screw in the
plasc rim.
OPERATION INSTRUCTIONS
1. Speed control: to turn on the fan, pressing the “ON/SPEED” buon. Once started, you
can select also the fan speed level pressing again this buon. To stop, press the “OFF”
buon.
2. Oscillaon: press the “SWING” buon and the fan will oscillate.
3. Tilng adjustment: the air ow can be adjusted upward or downward by simply mov-
ing the fan head up or down.
4. Timer: press the “TIMER” buon. The “0.5H” lamp on the control panel will turn to
indicate that the mer funcon is working.
The minimum ming is 0.5 hour, the maximum ming is 7.5hours. Press the mer buon
one me to increase 30 minutes (0.5 hours) each me.
Timer secuence: 0.5H→1H→1.5H→2H→2.5H→3H→3.5H→4H→4.5H→5H→5.5H→6H
→6.5H→7H→7.5H
If you press the buon again once reached the “7.5H” seng, all the lamps will turn o
and the mer funcon will be o.
This model also has remote control to control the funcons comfortably away from the
fan.
3. MAINTENANCE & CLEANING
CLEANING
• Before cleaning, always switch o the appliance, disconnect the appliance and let
it cool down.
• Clean the outside with a sponge or slightly wet linen.
• Do not use abrasive cleaners, gring, or metal brush or another cung object.
• The greasy dirt of the fan fuselage and the fan blade should be cleaned.
• Do not clean the fan with water directly.
• Do not wipe with acid detergent, lamp oil, alcohol or chemical cloth in case the co-
lour has changed or deteriorated.