Krober O2 - Initial Startup and Self-Test

Kröber O2 - Kröber O2 Vers. 4.0
Operation
EN 81
8 Operation
WARNING! Health risk!
Inappropriate use of the Kröber O2 can lead to severe personal and/or material
damage.
You should therefore only start up the unit in strict compliance with the
instructions for use and the notes on safety.
NOTE!
The adult and trained user may safely use all functions of the Kröber O2.
WARNING! Health hazard due to unsupervised operation.
Pay attention to the environmental conditions for safe operation. Keep infants,
animals or pests away from Kröber O2!
8.1 Taking into service
Fig. 24. Control panel
1 Start the unit by actuating the mains
switch (1) on top of the unit.
– The Kröber O2 runs a self-test.
– After the self-test, the software version
and then the operating hours are briefly
displayed.
– After the self-test the oxygen production
is started.
NOTE!
The sensor and the microprocessor
are automatically checked during
operation.
– The LC-display continuously shows the
current oxygen volume flow and the
equipment status.
NOTE!
After maximum 2 min, the unit will
reach its complete performance
according to the Technical
Specifications.
– Information on the operating status of
the device can be found on the display.
1