ii
FCC Notice
This equipment generates and uses radio frequency energy and, if not
installed and used in strict accordance with these instructions, may
cause interference to radio and television reception. It has been tested
and found to comply with the limits for a Class B computing device
pursuant to Subpart J of Part 15 of the FCC Rules, which are designed
to provide reasonable protection against such interference in a
residential installation. However, there is no guarantee that interference
to radio or television reception, which can be determined by turning the
equipment off and on, will not occur. The user is encouraged to try to
correct the interference by using one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the
receiver.
• Connect the equipment to an outlet on a branch circuit
different than the branch the receiver is connected to.
• Consult the dealer or an experienced radio/television
technician for help.
Note: To comply with FCC regulations, use only Kroy's recommended
serial cable when connecting the printer to a host computer (Kroy Part
Number 2506600). When installing the cable, the EMI filter should be
located 2-3" from the printer.
CDC Notice
This digital apparatus does not exceed Class B limits for radio noise for
digital devices as set out in the radio interference regulations of the
Canadian Department of Communications.
Le présent appareil numérique n’émet pas du bruits radioélectriques
dépassant les limites applicable aux appareils numériques de Classe B
prescrites dans le réglement sur le brouillage radioélectrique édicté par
le Ministére des Communications du Canada.
CDC Notice