Need help?Do you have a question about the KRUEGER QFC and is the answer not in the manual?
Overview of fan powered terminal units and their capabilities.
Describes available control options for the units.
Guidelines for proper storage and handling of units to prevent damage.
Checking units for damage upon receipt and removing packaging material.
Providing adequate clearance for unit maintenance and servicing.
Compliance with codes and methods for unit suspension during installation.
Information on the unit's warranty and available control options.
Pressure independent control packages with various features.
Control sequences for field-supplied controls from various manufacturers.
Pressure independent control packages for units with or without heat.
Units supplied without factory-installed controls, with standard sensors.
Guidance on choosing an appropriate installation location for fan powered boxes.
Instructions for safely raising and positioning the unit for installation.
Steps for connecting supply and discharge ductwork to the fan powered box.
Guidelines for compliant and safe electrical wiring of the unit.
Procedures for preparing the system for balancing and calibration.
Information on setting maximum and minimum airflow set points.
Steps for adjusting airflow set points using the inlet airflow sensor.
Items to check before balancing the system, including fan operation and filters.
Critical steps to follow for safe and proper unit operation and servicing.
Procedure for balancing series flow units by setting fan and VAV damper flow.
Steps for setting fan airflow, including disabling heat and checking fan rotation.
How to set primary air damper minimum and maximum airflow levels.
Information on adjusting the SCR speed controller for fan speed.
Procedures for setting fan airflow using ECM motors and various control options.
Balancing procedures for units with single-function pneumatic controllers.
Information on the multi-function reset volume controller and its use.
Steps for balancing supply outlets and unit fan discharge using control methods.
Procedure for measuring and adjusting primary air volume using a manometer.
Common problems and likely causes for pneumatic control system failures.
Steps for changing control logic and damper positions for different sequences.
Steps for installing and balancing analog electronic control systems.
Guidelines for mounting and wiring the thermostat for optimal performance.
Instructions for configuring thermostat sequences and setting airflow limits.
Guide for diagnosing issues in analog control systems.
Instructions for field-supplying and connecting hot water valves to the controller.
Information on accessing and maintaining the fan motor and wheel assembly.
Steps for checking and verifying motor wiring connections.
Checklist for diagnosing why the fan motor is not operating.
Causes and solutions for excessive noise when the fan motor is running.
Procedures for removing and servicing the fan motor and wheel assembly.
To Next Page
General
