13
The range hood includes lighting provided by two 4 Volt
2.5W LED light xtures.
LIGHTING
Always switch off the electrical supply before carrying out any
operation or maintenance on the appliance.
Wait for the light xture to cool before touching. LEDs can remain hot
for some time after turning off.
!
!
1. Remove the mesh lter and locate the locking spring of the light.
2. Push the spring and the light can be removed.
3. Change the light as with an identical 4 Volt, 2.5 Watt LED light.
MESH FILTER
The mesh lter should be cleaned frequently; minimum every two months,
or more for frequent to heavy use.
1. Remove the grease lters individually by pulling on the latch. This will
disengage the lter from the hood. Tilt the lter downward and remove.
2. Wash the lters, taking care not to bend them. Allow them to dry
completely before reinserting.
3. When inserting the lters, make sure that the latch handle is visible from
the outside.
4. Align the rear of the lter tabs with the slots in the crease. Pull out the
latch, push lter into position and release.
5. Make sure the lter is securely engaged after assembly.
To Next Page
Loading...
