Krups 314 User Manual

~
Display
aroma
..
for 4-10 cups of
coffee; delivers
a stronger, more
stimulating
coffee, with a
powerful aroma.
CYJm
aroma
-
for 1-3 cups' of
I L -31 I coffee; full flavor
i andaroma
Approximately 4 seconds after you have
made your aroma selection, the time will
reappear in the display window. Please
note that the last-selected aroma setting
will remain in memory until manually
changed to a different selection.
To begin the brewing process, press the
"ON/OFF" button ~ (p). The indicator light
will illuminate, indicating the brewing
process has begun (see figure.).
Carafe Pre-Warming Cycle
This feature allows you to pre-warm the
carafe before the brewing process begins.
Follow the steps in "Filling the Water
Chamber" and "Putting in the Ground
Coffee" .
To start the process, select the coffee
strength you desire using the "aroma"
button.. (k). Within 6 seconds, press the
carafe pre-warm button Ii (j). The display
will say "on". Pressthe
Oii! button (p). The
indicator light will flash, indicating that you
have chosen to pre-warm the carafe. Pre-
heating takes approximately 5 minutes,
after which the brewing process will
automatically begin. Once the carafe is
pre-heated, the indicator light will stop
flashing, but remain solid red.
8
& Note!
Once you press the carafe pre-warm
button, the function is stored in memory.
The next time you make coffee, the carafe
will automatically be pre-warmed.
The function can be cancelled by pressing
the carafe pre-warm button during the pre-
warm stage. The light will then remain solid
red. Carafe pre-warming is automatically
cancelled in the event of a power shortage
or removal of plug.
Aroma Savor Lid
When the brewing cycle is complete, the
last drop to leave the filter seals the opening
within the lid of the carafe. When pouring,
the stream of coffee forms a seal on the
carafe lid so the remaining coffee is in an
airtight container. This reduces evaporation
and heat loss, and protects the aroma and
freshness of the coffee.
"Stop'n Serve" Feature
The "Stop'n Serve" feature is KRUPS'
answer to the impatient coffee drinker's
clamor for "a quick cup of coffee!" This
device automatically stops the flow of
brewed coffee through the filter cone if the
glass carafe is removed from the warming
plate during the brewing cycle. You have
about 20 seconds between the removal of
the carafe and its being reinserted to allow
the serving of one or two cups of coffee.
The "Stop'n Serve" device closes off the
filter cone so effectively that there is
virtuany no coffee-drip onto the warming
plate (one drop, at most!).
Once the carafe is replaced, the brewing
cycle and the flow of the coffee into the
carafe are resumed.

Krups 314 Specifications

General

Brand	Krups
Model	314
Category	Coffee Maker
Language	English