1 - WHISK, MIXER, MULTI-BLADE MIXER: kneading, mixing, beating, emulsifying, whisking
1.1 A
SSEMBLY
n Check that the speed selector (a3) is set at “0” (fig. 1).
n Insert the rods of the whisks (a6), mixers (a7) or the multi-blade whisk (depending on model) (a8) into
the corresponding holes. The multi-blade whisk (depending on model) can be inserted into the left or
right hole on the body of the appliance. Once inserted, the two whisks must be the same length. The
“click” indicates that the accessories are correctly in place (fig.2).
n Connect the appliance.
1.2 U
SE
n Depending on the quantity to be prepared, place the ingredients in the container provided (1 l bowl (e)
or 2.5 l bowl (f) depending on the model) or in a suitable container (bowl or beaker, preferably shallow).
Place the whisks (a6) or mixers (a7) in the container and turn the appliance on using the button (a3).
To prevent splashes when you start or for delicate preparations (creams and sauces), the appliance has
a non-splash function "M setting" to whisk or mix the ingredients on a very low speed to prevent
splashing.
To use:
- Press and hold the button (a3) to the left at the M setting. (fig. 3).
- Release the button to return to the “0” setting.
- Continue the preparation by selecting a faster speed (fig. 4).
n Turn the appliance on using the speed selector (a3). Increase the speed gradually as the preparation
thickens (fig. 4). Your appliance has a Turbo button which instantly provides full power by simply pressing
the button (a2) (fig. 5). Do not use the appliance for more than five minutes with the whisk or five
minutes with the mixers, when at maximum speed or in the Turbo setting.
1.3 D
ISASSEMBLY
n Switch the appliance off before removing the whisks or mixers from the preparation (to avoid splashing).
Return the button to the “0” setting (fig. 1).
n Disconnect the appliance.
n Release the whisks, mixers or the multi-blade whisk (depending on the model) by pressing the ejection
button (a4) (fig. 6).
1.4 C
LEANING
n Disconnect the appliance.
n The whisks, mixers or the multi-blade whisk (depending on the model) must be removed before cleaning
(fig. 6).
n Clean the whisks, mixers or multi-blade whisk (depending on model) immediately after use to prevent
any remaining egg or oil mixture sticking or drying.
n You can clean the whisks, mixers or the multi-blade whisk (depending on model) with a sponge and
washing up liquid. They are also dishwasher-safe.
n Clean the body of the appliance using a damp sponge only and dry carefully.
n Never place the appliance in the dishwasher.
n Do not use scouring pads or objects containing metal parts.
n Never immerse the body of the appliance in water (fig. 7).
2 - BASE SUPPORT ACCESSORY WITH ROTATING BOWL: kneading, mixing, beating, emulsi-
fying, whisking (depending on model)
2.1 A
SSEMBLY
n The base support is used with the mixer equipped with whisks or mixers. To use these accessories, refer
to section 1 – WHISK, MIXER
n Never use the multi-blade whisk with the base support.
USING THE APPLIANCE
English
18
To Next Page
Loading...
