Place the sieve back Into the brewing head
and screw firmly Into place (see figure 26).
The steam nozzle must be wiped with a
mOist cloth Immediately after frothing.
This will prevent the milk from drying onto
the nozzle and clogging the steam hole.
However, should the nozzle become
clogged, the nozzle can be removed with a
COinand cleaned uSing a needle. Ensure the
rubber nng ISIn position when replacing the
steam nozzle (see figure 27).
Ifthe machine will not be used for any length
of time, we recommend not leaving the filter
holder Inside the brewing head, as this puts
'the sealing nng under unecessary pressure,
which can shorten the life ofthe sealing nng.
Decalcifymg.
Under normal conditions you do not need to
decalcify your ~Novo Compact~rNovo
Compact Latte" However, In areas where
there IShard water or ifyou use your machine
very frequently we recommend decalcifying.
"Youwill know when such a cleanrng IS
necessary by an obvIous slow down In the
brewing time. Decalcifier ISwJdely available
and can be purchased through KRUPS
Consumer Service Department.
How To Decalcify
. Before beginning, it IS necessary to
remove the brewing sieve from the
brewing head (see figure 26). This can be
done uSing a flat head screw dnver or COin.
.Remove the water reservoir and fill it with
luke warm water. Dissolve the decalcifying
solution IOtO the water reservoir. Replace
the water reservoIr.
14
..
. Place a cup underneath the brewing spout.
. Turnthe controldialto the" .Q' " position.
Stop between eachcup and empty itas it
becomes full. Proceed with this until all of
the water has run through the machine.
Allow the appliance to cool for 10-15
minutes when done.
. To eliminate traces of the decalcifying
solution, fillthe water reservoir with
fresh, cold water.
. Turn the control dial to the" .Q' " position
and clean the machine until there ISno
more water Inthe reservoir.
Problem:
Coffee does not come out of filter holder.
Cause:
. No water Inthe water reservoir.
. Water reservoir not Inserted correctly.
. Filter blocked because the coffee mixture
IStoo fine or has been tamped too hard.
. Machine needs to be decalcified.
Problems and Causes
Problem:
Espresso has no "Crema"
Cause:
. Old or dried out coffee being usee.
. Coffee not suitable for espresso.
. Coffee ground too coarsely.
. Too little coffee Inthe filter or not
properly tamped.
Problem:
Coffee leakmg from filter holder.
Cause:
Problem:
Not enough froth when frothrng milk.
Cause:
. Steam nozzle IS clogged.
. Milk IS not fresh.
. The pitcher that you are using ISnot suitable.
(It IS recommended that you use a starnless
steel.frothlng pitcher.) Cold conducts
better to metal than to glass or plastic.
. The type of milk IS not suitable. We
recommend uSlOg 2% or skim milk.
Whole milk IS acceptable, but due to the
fat molecules, it will not have as dense a
froth as if you were to use 2% or skIm milk.
. Filter holder not properly Inserted In the
machine.
. Filterholder not pushed In as far as it willgo.
Problem:
Pump makes. loud nOise.
Cause:
. No water 10the water reservoir.
. Old or dry coffee ISberng used, water
cannot properly flow through the coffee.
LimitedOne YearWarranty
Your KRUPS #989 or 882 IScovered by the
following warranty:
Iffrom date of purchase within one year thIs
KRUPSproduct fails to function because of
defects 10matenals or workmanship,
KRUPS North Amenca will, at its option,
repair or replace the unit with our charge,
provided the owner has a proof of date of
purchase. .
This warranty will be vOid jf malfunction
was caused by damage to the product by
accident, misuse, use on frequency or
voltage other than marked on the product
and/or described Inthe Instructions, abuse
IOcludingtampenng, damage In transit, or
use for commercial purposes. This warranty
gives you specificlegalnghts, and you may
also have other rrghts which may vary from
state to state.
15
To Next Page
Loading...
Need help?
General
