KRUPS SERIE EA9000
20
INSTALLING THE CLEANING LIQUID
n Press “Now” to confirm or “Later” to do it later.
n Open the left door (15). Pull the container (19) and screw the bottle (18) onto
the container.
n Replace the container back with the bottle and close the door.
n Do not screw in the bottle fully.
n The bottle must be positioned in line with the drawer.
AUTOMATIC STEAM NOZZLE CLEANING PROGRAMME
n Your machine will prompt you to start this programme.
n To do so, press “Now“. The cycle will last about 5 minutes and the screen will
display the progress of the cleaning.
PREHEATING, AUTOMATIC MAINTENANCE, RINSING
n The machine will start by preheating the circuits, then will carry out an
automatic test and finally will ask you if the appliance needs to be rinsed or
not.
n Place a container under the coffee nozzles and press YES if this is required.
The rinsing procedure starts and stops automatically, after around 40 ml have
passed through.
n The main drink selection menu is then displayed on the screen.
h
Important: Ensure that all of the lids, covers and doors are closed and that all parts of the machine are
fitted correctly before starting to prepare a drink.
!
Note: If the first use cycle is interrupted before it has fully completed, you will be asked to save certain
parameters again or to confirm certain settings.
!
IFU_EN_KR_COFFEEMAKER_BARISTA_0A10475_Mise en page 1 14/05/12 09:42 Page20
To Next Page
Loading...
