12
• Turn the function selector (d) to the position
«
» until the liquid is hot enough, then
reset the function selector (d) to the off
position O and remove the container.
• For instructions on cleaning the Auto
Cappuccino accessory, please refer to the
paragraph «Maintenance».
Important notes :
The thumping noise which occurs while steam
is being produced comes from the intermit-
tent regulation of the pump and has no effect
on the proper working of the appliance.
Caution : During and after use of the
machine, the metallic parts of the Auto
Cappuccino accessory can become extremely
hot.
• We advise you to clean the auto-cappuccino
accessory immediately after use ; please
refer to the paragraph «Maintenance».
• If you wish to make an espresso immediately
after steam, the appliance must first cool
down :
. place a container under the empty and
correctly positioned filter holder, then turn
the function selector (d) to the position
«
».
. let water run through until the indicator
light (f) goes out. Then, turn the function
selector (d) to the position O.
After this, the machine is ready once again to
make espressos (see paragraph «Espresso
function»).
3. HOT WATER FUNCTION
Please note : If you prepare hot water
immediately after using the steam function,
steam may come out of the nozzle before hot
water is produced.
• Fill the water tank (b) and turn the switch
(e) to «I». The indicator light (e1) comes on.
• Turn the steam/hot water selector (g) to the
position «
».
• Turn the steam tap (k1) to the position
«
».
• Place the container under the nozzle (k2)
(8). If necessary, adjust the height of the grid
support (4). The tip must not touch the
bottom of the container so as not to prevent
the passage of water.
As soon as the appliance reaches the right
temperature, the indicator light (f) comes on.
• Turn the function selector (d) to the position
«
».
• Once you have obtained the desired quantity
of water, turn the function selector (d) to the
off position O.
Maintenance
Note : Never wash the accessories for your
espresso maker in the dishwasher.
• Unplug the appliance and allow it to cool
down.
• You can clean the body of the appliance
with a damp cloth.
After usage, the water tank should be
emptied to avoid limescale build-up.
. The drip tray (n)
• Each time an espresso is prepared, the drip
tray (n) fills with water. This is perfectly
normal. If there is any water in the fill
indicator (n1), you must then empty the drip
tray.
• Take off the grid and its support (11) and
empty the drip tray (n).
• If necessary, clean the drip tray and the grid
with water and a little non-abrasive iquid
soap, rinse and dry. When replacing, put
back the plastic block situated at the back of
the tray (12).
. The percolation head and the filter
holder
Warning : these may be extremely hot.
These must be cleaned after every use. Simply
run a damp cloth over the percolation head
and clean the other accessories with water
and a small quantity of non-abrasive liquid
soap. Rinse and dry.
• If the percolation head (h) becomes heavily
encrusted, unscrew its grid using a coin,
clean it and replace, tightening it firmly (13).
• If the filter holder (j) becomes heavily encrus-
ted, unscrew its grid using a coin, clean it
and replace it, tightening it firmly (14).
. The seal for the percolation head
When you are not using your espresso maker,
do not leave the filter holder in the appliance
in order to prevent wear on the seal.
To Next Page
Loading...
