13
CLEANING
INSTRUCTIONS
The explanatory drawings are on page 58
Put the appliance on a rm surface.
Before using:
Fully unwind the lead.
Open the appliance.
Remove all packaging, labels or accessories from the inside and outside of the appliance.
Coat the plates lightly with cooking oil or spray with a non-stick aerosol.
Wipe with a soft cloth.
Using your appliance
Close the appliance.
Check that the switch is set at 0.
Connect the lead to the mains. Set the switch (f) to on (position 1). The red light (d) comes
on (1).
Leave the appliance to pre-heat: the green light (e) comes on when the cooking
temperature has been reached (2).
Open the appliance (3). Using a ladle, pour the wafe batter onto the lower plate of the
appliance.
Pour the batter taking care to cover each square and not to let it overow.
Close the appliance.
Leave to cook for the time stated in the recipe.
While the wafes are cooking it is normal for the green light to switch on and off.
At the end of cooking, switch the appliance off by pressing 0. Then disconnect the plug.
Leave to cool for 2 hours.
DESCRIPTION
A Wafe plates xed with non-stick (2)
B Thermo-insulating handle
C Locking clip
D Appliance switched on light
E Setting light
F Switch
Always disconnect the appliance before cleaning, and leave to cool completely.
Do not immerse the appliance.
To clean the exterior,
wipe with a damp cloth and dry.
To clean the interior,
wipe the plates with a damp cloth, some dishwashing soap may be used. Then wipe with a
wet sponge and dry carefully.
To Next Page
Loading...
Need help?
General
