1
Rinse water tank manually with freshdrinking water. Fill
water tank with freshdrinking water. Insert water tank into
machine.
2
Open locking handle. Make sure that rinsing tool is in
capsule holder and capsule holder is in machine. Close
locking handle. Place a large empty container underneath
the coffee outlet.
3
Make sure that the selectionlever is in “STOP” position.
Ensure to use the correct mains voltage as given in 2.
"MACHINE OVERVIEW" on page5. Connect power plug to
mains power socket.
4
Switch on machine. Power button starts blinking red while
machine is heating up for approximately 40 seconds.
Afterwards power button lights steady green. Machine is
ready to be used.
5
Push selection lever to the "COLD" position. Machine starts
rinsing.
6
After approximately 60 seconds push selection lever to the
“STOP” position. Machine stops rinsing. Power button
blinks red for about 5 seconds.
7
Push selection lever to the "HOT" position. Machine starts
rinsing.
8
After approximately 60 seconds push selection lever to the
“STOP” position. Open locking handle. Pull out capsule
holder. Remove rinsing tool. Reinsert capsule holder.
9
Empty container. Fill water tank with freshdrinking water.
Insert water tank into machine.
9
5. FIRST USE
To Next Page
Loading...
