18 19
Note! When the indicator light «empty
collector» is on or flashing, the
appliance will not operate.
• Empty the tray when the full indicator reaches
the marking (25).
Note! If you remove the tray and the
coffee collector before the indicator light
«empty collector» comes on, always
empty both these parts.
Turning off the appliance
• Place the container under the coffee outlets and press the control .
A rinse is done automatically after the appliance is turned off.
Note! The rinse is also performed when the appliance switches itself
off automatically.
Cleaning and maintenance
1. Cleaning and maintenance
•Unplug the appliance before cleaning it and allow it to cool down.
•Do not use any cleaning tools or products which might scratch or corrode
the appliance.
•Never place the appliance nor any of its components in a dishwasher.
- The body of the appliance:
•Clean the exterior and interior using a damp cloth.
- The detachable parts:
• Clean the tray, the coffee collector, the drip
tray grid with hot water and washing-up
liquid (26).
• Rinse carefully using fresh water.
- The steam nozzle:
Warning! The nozzle may still be burning hot.Take care not to burn
yourself. Do not remove or replace the nozzle if it is still hot.
• Clean the nozzle using a damp cloth.
• If the head of the nozzle is obstructed:
• Unblock it using a fine needle or unscrew it,
turning clockwise, using the key situated on
the handle of the measuring spoon (27).
•Run it under hot water. Screw it back on
anti-clockwise, using the key.
- Frothing aid:
•To clean the frothing aid separate parts A
and C from the metal tube B (28).
• Rinse the three parts in hot water.
• If the little aspiration hole in part A is
blocked,clean it using a fine needle.
2.Programme for cleaning the internal circuits
As soon as the indicator light «clean» comes on, you should clean the circuits.
The cleaning programme takes about 15 minutes.
Note! The indicator light comes on after 250 preparations of
espresso or after 180 rinses.
You can continue to use the appliance, but it is advisable to
run the programme as soon as possible.
Warning! Use only KRUPS cleaning tablets. No liability can be accepted
for any damage arising from the use of other brand of tablets.
You can obtain cleaning tablets from the KRUPS authorised
dealer - 0121 200 2740
Proceed as follows:
•Plug in the appliance but do not turn it on.
The steam/hot water selector must be in the position .
•Fill the water tank.The cleaning programme needs about 1.25 litres of water:
the tank must therefore be 2/3 full. Replace the tank on the appliance.
KRUPS KRUPS
Indicator LightsIndicator Lights
25
26
27
28
a
b
b
To Next Page
Loading...
Need help?
General
