28
pressing the coffee button (9) as many
times as necessary.
• Then rinse with two water containers of
fresh water, clean the brewing head and
replace the grid on the head of the machine
(see section on Cleaning the Machine).
Troubleshooting
Problems Probable causes Corrective actions
Espresso not hot Cups, filter and Preheat the
enough filter holder accessories (cups,
are cold. filter, filter holder)
See paragraph
“Preparing an
espresso”.
Coffee leaks The filter holder See paragraph
around the filter is not mounted “Preparing an
holder correctly or has espresso”.
not been tightened
sufficiently.
There are coffee Clean around the
grounds on the filter and the
edge of the filter. gasket.
The brewing head Clean the gasket
gasket is dirty. with a damp cloth.
The brewing Contact an
head gasket approved Krups
is defective. service centre.
Pump is very noisy No water in the Fill the water tank.
water tank.
Water tank incor- Press firmly down
rectly mounted. on the water tank.
Coffee grounds Use fresh coffee.
too old or very dry
and the pump
cannot produce
pressure.
Water does not No water in the Fill the water tank.
run through. water tank.
Water tank incor- Press firmly down
rectly mounted. on the water tank.
The filter is Clean the filter and
blocked, the coffee the grid on the
grounds are too brewing head.
fine or tamped See the paragraph
down too hard. “Maintenance” and
try a coarser coffee.
Brewing head Put the grid to
grid is encrusted. soak in descaling
solution.
See paragraph
“Maintenance”.
Descaling
Descaling is necessary to keep your espresso
maker running efficiently.
• Your espresso maker should be descaled on
a regular basis.
• Use caution when descaling your espresso
maker as the acid substance within the
descaling powder may damage worktops or
any other surface it comes in contact with.
• The warranty of this machine does not
include espresso makers that do not
function, or do not function properly,
because descaling has not been carried
out.
We would advise you to use the Krups
descaling solution that is available from Krups.
Descaling depends on the hardness of the
water, but also on the frequency of use.
- To descale follow the following method:
• Remove the Claris-Aqua Filter System
cartridge (accessory not provided) if you
have fitted one.
• Unscrew the grid from the head of the
machine and clean it (21).
• Dissolve a packet of KRUPS descaling
solution in 500 ml of lukewarm water and
pour the whole batch into the empty water
container.
• Start the machine (4).
• Place a container, as large as possible,
beneath the auto cappuccino accessory.
As soon as the start/stop switch begins to
glow continuously, the machine is ready.
• Press twice the steam / hot water button
/
(P), and run through 1/3 of the liquid.
• Press the hot water / steam button again
/
(P) to stop.
• Move the container under the brewing
head.
• Run the second third of the liquid
immediately by pressing the coffee button
(9) as many times as necessary.
• Stop the machine by pressing the start/stop
switch
(N) and wait for 10 - 15 minutes
to allow the descaler to take effect.
• Next, start the machine again
(N) and
allow the rest of the liquid to run through by
XP2070 anglais.P65 7/11/05, 12:3228
To Next Page
Loading...
Need help?
General
