To Next PageTo Next PageHow to fix downstream or upstream leakage in KSB ISORIA 10?
To address downstream or upstream leakage in your KSB Control Unit: open the valve, line without fluid or flow, remove any particles, inspect the liner and disc, and replace the liner or disc if necessary.
What to do if disc is damaged or corroded in KSB Control Unit?
If the disc of your KSB Control Unit is damaged or corroded, check the flanging dimensions and replace it using the disc kit.
How to resolve a broken or twisted shaft in KSB Control Unit?
If the shaft of your KSB Control Unit is broken or twisted, analyze the defect, research the causes, and replace the shaft.
Identifies hazard symbols and warnings used in the manual.
Highlights risks from ignoring safety instructions, including warranty forfeiture.
Covers protection of hot/cold parts and hazardous substance handling.
General safety rules for maintenance, inspection, and installation work.
Prohibits unauthorized modifications and use of non-genuine parts.
Warns against exceeding specified limits and operating outside designated use.
Key considerations for installing valves to prevent damage.
Safety instructions for maintenance and repair work.
Steps for safely removing the valve and disconnecting the actuator.
Emphasizes qualified personnel and use of genuine parts for repairs.
Lists common faults and their corresponding remedies for valve issues.
Identifies hazard symbols and warnings used in the manual.
Highlights risks from ignoring safety instructions, including warranty forfeiture.
Covers protection of hot/cold parts and hazardous substance handling.
General safety rules for maintenance, inspection, and installation work.
Prohibits unauthorized modifications and use of non-genuine parts.
Warns against exceeding specified limits and operating outside designated use.
Key considerations for installing valves to prevent damage.
Safety instructions for maintenance and repair work.
Steps for safely removing the valve and disconnecting the actuator.
Emphasizes qualified personnel and use of genuine parts for repairs.
Lists common faults and their corresponding remedies for valve issues.
General| Type | Control Unit |
|---|---|
| Model | ISORIA 10 |
| Power Supply | 24 V DC |
| Protection Class | IP 65 |
| Housing Material | Plastic |
| Digital Inputs | 4 |
| Display | LCD |
| Storage Temperature | -20 °C to +70 °C |
| Weight | 0.5 kg |
| Digital Outputs | 4 |
| Analog Inputs | 2 |
| Configuration | Via Modbus RTU |
| Humidity | Max. 95 % RH, non-condensing |
