metal piece it fits into the hole.
1.5 Charging
The Venture smartwatch’s full charge time is approximately
4 hours, and the battery can last up to 10 days depending on
the usage.
Use the 60 cm USB-A cable with magnetic wire cable that is
included in the box to charge the smartwatch. Connect the
USB-A connector to a charger, computer output or power
bank and place the magnetic wire cable in a way so that it
properly sticks to the back part of the watch body.
1.6 Power on/off, restart and reset
To turn on the smartwatch, long-press the power dial button
for 5 seconds.
To turn off the smartwatch, long-press the power dial button
for 3 seconds.
If you want to restart or reset your Venture, enter the System
section in the Settings.
1.7 About IP protection rating
The Venture smartwatch has a IP68 protection rating.
Disclaimer: Although the watch has an IP68 protection
rating, we do not recommend direct and prolonged contact
with water, or use in saunas or steam baths. We do not
recommend swimming in the sea or in swimming pools
(both fresh and salt water). In the event that this happens, it
is recommended that the watch be rinsed with fresh water
after immersion, due to the corrosive effect of chlorine or salt
water. If the watch has an auto-drain function, it is also
recommended to use it after rinsing.
2. Initial setup
2.1 Download the app
The Venture smartwatch compatible app is called Da Fit.
There are several ways to download it:
- Tap here to download the Da Fit app from Google Play or
App Store.
- You can also download the app directly by typing “Da Fit”
in the Google Play or App Store search engine.
2.2 Register in the app
To Next Page
Loading...
