1.Please read all the instructions carefully before using the product.
2.When cleaning the display, unplug the power cord. Wipe the display with a soft wet cloth
instead of liquid or spray cleaner. Use LCD screen cleaner in case of a stubborn stain.
3.Do not use accessories that are not recommended by the manufacturer, or there may be
dangerous.
4.When unplugging the power cord of the display or the power adapter, please hold the power
plug with your hand rather than directly pull the power cord to unplug it.
5.Do not place the display near water, such as bathtub, washbasin, kitchen sink, or washing
machine. Do not place the display on the wet ground, or near the swimming pool. Do not use
fingers or hard objects to press the surface of the LCD screen.
6.The grooves and holes on the shell or at the back and bottom of the display are designed for
the ventilation and heat dissipation of the components to ensure reliable operation. So, do not
put the display on the bed, sofa, carpet, or other similar surfaces to prevent the heat dissipation
holes from blocking and do not place the display near or above the radiator or heater. In addition,
do not place the display in an embedded device unless adequate ventilation is provided.
7.Only the power supply type shown on the nameplate can be used for the display. Please feel
free to consult the display dealer or the local power supply administration, if you have any
doubts about your power supply type.
8.For safety, the display or the power adapter uses a power cord with a three-prong plug, whose
third prong can only be properly grounded when used with a properly grounded socket. If your
socket cannot match with the plug, please contact an electrician to replace your original socket
so that the plug can give full play to ensuring safety.
9.As you may face high voltage or other dangers after removing the shell, please do not repair
the display by yourself. You can have it repaired by relevant qualified maintenance personnel.
10.Please unplug the power cord of the display or the power adapter from the socket, and
contact qualified maintenance personnel for repairing the display, when following cases occur:
a.The power cord or the plug is damaged or worn out.
b.The display has been dropped from high or the shell is damaged.
c.Any obvious abnormality indicates a necessary repair.
11.Please place the display in a well-ventilated environment, which is away from strong light,
high temperature, or humidity.
12.The room temperature for the display store is -10°C～60°C, or it may be permanently
damaged.
Important Safety Precautions
To Next Page
Loading...