What to do if KTM Motorcycle engine turns although a gear is engaged?
Check the safety start system. Reconnect coupling of fuel hose connection. Clean the socket connector and treat it with contact spray.
Why does my KTM 2011 990 Supermoto R USA engine overheat?
Your KTM Motorcycle engine may overheat due to several reasons: there may be too little coolant, leaks in the cooling system, or low antifreeze/coolant levels. The radiator fins could be very dirty, or there could be foam formation in the cooling system. Other potential causes include a buckled or damaged radiator hose, a blown FAN fuse, a defective thermostat or radiator fan system, or air in the cooling system. Clean the radiator fins or change the radiator hose. You can also check the thermostat or radiator fan system. In case of foam formation or air in the system drain and fill/bleed the cooling system.
Why does my KTM 2011 990 Supermoto R USA Motorcycle engine die during a trip?
Your KTM Motorcycle engine might die during a trip due to a lack of fuel, so refuel. Another possible cause is a blown IGNITION, FUEL PUMP, or POWER RELAY fuse; in this case, change the fuses.
Why is my KTM Motorcycle battery discharged?
If your KTM Motorcycle battery is discharged, it could be because the ignition was not switched off when the vehicle was parked, so recharge the battery. Alternatively, the battery may not be charged by the alternator, so check the charging voltage.
What to do if the warning lamp FI (MIL) lights up/flashes on my KTM Motorcycle?
If the FI (MIL) warning lamp lights up or flashes on your KTM Motorcycle, it indicates a defect in the fuel injection system. Use the KTM diagnostics tool to read out the fault memory.
Why does the combination instrument show nothing in the display on my KTM Motorcycle?
If the combination instrument display on your KTM Motorcycle is blank, check fuse 6 and replace it if it's blown.
What to do if my KTM 2011 990 Supermoto R USA engine turns although a gear is engaged?
If your KTM Motorcycle engine starts even when a gear is engaged, there may be a defect in the safety start system, so check the safety start system. Another possible cause is a coupling of fuel hose connection not connected, so reconnect coupling of fuel hose connection. Also, the socket connector of wiring harness could be oxidized, so clean the socket connector and treat it with contact spray.
Why is the speedometer in combination instrument not functioning on my KTM Motorcycle?
If the speedometer in your KTM Motorcycle combination instrument isn't working, the wiring harness of wheel revolution counter may be damaged or the plug-in connector might be oxidized, so check the wheel speed sensor.
What to do if the combination instrument shows nothing in the display of my KTM 2011 990 Supermoto R USA Motorcycle?
If the combination instrument shows nothing in the display on your KTM Motorcycle, the ACC1, CLOCK fuse may be blown, so change the fuse.
What to do if the turn signal, hazard warning flasher, brake light and horn are not functional on my KTM 2011 990 Supermoto R USA?
If the turn signal, hazard warning flasher, brake light, and horn are not functional on your KTM Motorcycle, the HORN, BRAKE LIGHT, SPEEDO fuse may be blown, so change the fuse.
General| Displacement | 999 cc |
|---|---|
| Bore x Stroke | 101 mm x 62.4 mm |
| Compression Ratio | 11.5:1 |
| Fuel System | Electronic fuel injection |
| Starter | Electric starter |
| Transmission | 6-speed |
| Clutch | Wet multi-disc clutch, hydraulically operated |
| Front Suspension | WP USD 48mm |
| Rear Suspension | WP monoshock |
| ABS | Optional |
| Front Tire | 120/70 ZR17 |
| Rear Tire | 180/55 ZR17 |
| Ground Clearance | 270 mm |
| Fuel Capacity | 15 liters |
| Engine Type | V-Twin, 4-stroke |
| Torque | 100 Nm |
| Ignition | Digital |
| Lubrication | Pressure lubrication with 2 oil pumps |
| Cooling | Liquid |
| Frame | Steel trellis |
| Rear Brake | 240 mm disc |
| Front Wheel | 17 in |
| Rear Wheel | 5.5 x 17" |
| Weight | 199 kg |
To Next Page