Why is my KTM 250 SX-F EU 2017 engine overheating?
If your KTM Motorcycle engine overheats, check the coolant level and inspect the cooling system for any leaks. Ensure there's sufficient airflow, and if standing still, switch off the engine. Clean the radiator fins if they are dirty. If there is foam formation in the cooling system, drain and refill the coolant. Finally, inspect the radiator hose; if it's bent, replace it.
Why does my KTM Motorcycle have high oil consumption?
If your KTM Motorcycle engine consumes a lot of oil, ensure the engine vent hose is correctly routed without any bends, replacing it if necessary. Check that the engine oil level isn't too high. If the oil is too thin, replace the engine oil and oil filter, and clean the oil screen.
What to do if my KTM 250 SX-F EU 2017 engine turns but does not start?
If your KTM Motorcycle engine turns over but doesn't start, make sure the fuel line plug-in connection is properly connected. If the fuel screen in the fuel hose connection is clogged, replace it. Ensure the idle speed is correctly set. Clean and dry the spark plug, or replace it if needed. Adjust the plug gap to the recommended 0.8 mm (0.031 in). Check the wiring harness and electrical system for shorts or defects. If there is a defect in the fuel injection system, read out the fault memory using the KTM diagnostics tool.
How to fix KTM Motorcycle when the engine does not turn?
If your KTM Motorcycle engine doesn't turn when you press the electric starter button, make sure you are following the correct start procedure. Check if the battery is discharged and recharge it if necessary. Also, check the charging voltage, open-circuit current, and the stator winding of the alternator. Replace the main fuse if it's blown. Check the starter relay and the starter motor for faults.
Why does my KTM 250 SX-F EU 2017 Motorcycle engine have too little power?
If your KTM Motorcycle engine has too little power, start by cleaning the air filter and air filter box. Replace the fuel filter if it's very dirty. Check the exhaust system for leaks or damage, and replace the glass fiber yarn filling in the main silencer if needed. Also, make sure to adjust the valve clearance if it's too little. If there is a defect in the fuel injection system, read out the fault memory using the KTM diagnostics tool.
What to do if the malfunction indicator lamp lights up on my KTM 250 SX-F EU 2017?
If the malfunction indicator lamp on your KTM Motorcycle lights up or flashes, stop the motorcycle and identify the faulty part using the blink code. Also, inspect the cabling for any damage and check the electrical plug-in connections for corrosion and damage.
General| Bore x Stroke | 78 x 52.3 mm |
|---|---|
| Compression Ratio | 14.4:1 |
| Transmission | 5-speed |
| Ignition | Keihin EMS |
| Starter | Electric starter |
| Ground Clearance | 370 mm |
| Front Tire | 80/100-21 |
| Engine Type | Single-cylinder, 4-stroke |
| Displacement | 249.9 cc |
| Fuel System | Keihin EFI, 44 mm throttle body |
| Cooling System | Liquid-cooled |
| Clutch | Wet multi-disc |
| Front Suspension | WP USD, 48 mm |
| Rear Suspension | WP monoshock |
| Front Brake | Brembo, 260 mm disc |
| Rear Brake | Disc brake, 220 mm |
| Wheelbase | 1485 mm |
| Fuel Tank Capacity | 7.0 liters |
| Rear Tire | 100/90-19" |
| Frame | Central tube frame made of chrome molybdenum steel |
To Next Page
