Need help?Do you have a question about the KTM 300 MXC and is the answer not in the manual?
General| Starter | Kickstarter |
|---|---|
| Bore x Stroke | 72 mm x 72 mm |
| Fuel System | Carburetor |
| Rear Suspension | WP monoshock |
| Front Brake | Single 260mm disc |
| Rear Brake | Single 220mm disc |
| Fuel Tank Capacity | 9.5 liters |
| Frame | Chromium-Molybdenum steel |
Crucial safety instructions and their potential consequences for operation.
Specific consumer advice, especially for Australia regarding noise control.
Guidance for initial operation and familiarization with controls.
Emphasis on approved parts and dealer service for longevity.
Specifies models prohibited on public roads and usage rules.
Location of chassis and engine serial numbers.
Description and adjustment of clutch and hand brake levers.
Overview of the speedometer's display modes and functions.
How to activate, deactivate, and cycle through display modes.
Operation of short circuit, emergency, and headlamp switches.
Managing the fuel tap, filler cap, and choke for starting.
Adjusting compression and rebound damping on the front fork.
Recommendations for new riders and initial familiarization.
Correct procedure for breaking in the engine components.
Essential checks before every ride for safety and function.
Steps for starting the engine in various conditions.
Guidance on riding, shifting gears, and throttle control.
Proper methods for braking, stopping, and parking.
Information on fuel type, mixture, and safe refueling practices.
Key maintenance tasks for KTM workshop service.
Routine checks and maintenance performed by the rider.
How to adjust the shock absorber's spring preload.
Adjusting suspension based on rider's weight.
Checking static and riding sag for proper setup.
Adjusting spring preload on telescopic forks.
Replacing fork springs and cleaning dust sleeves.
Modifying the fork offset for handling characteristics.
Ensuring proper steering head bearing play.
How to check and adjust chain tension and wear.
Information on disc brakes, fluid, pads, and discs.
Procedures for replacing front and rear brake pads.
Steps for dismounting and mounting the front and rear wheels.
Checking tire pressure, condition, and spoke tension.
Checking coolant level and system operation.
Carburetor settings, wear, and operational definitions.
Procedures for checking and changing transmission oil.
Cleaning, winter operation, and long-term storage guidelines.
Steps to take before riding the motorcycle after storage.
Detailed specs for frame, fork, suspension, and brakes.
Specified torque values for chassis component fasteners.
Details on engine design, displacement, ignition, and transmission.
Specified torque values for engine component fasteners.
Base carburetor settings for various models and conditions.
To Next Page
