ENGLISH
51
TECHNICAL SPECIFICATIONS – CHASSIS 250 SX, EXC, 300 MXC, EXC »
TIGHTENING TORQUES – CHASSIS
Collar screw, front wheel spindle M24x1,5 40 Nm
Brake caliper, front M8 Loctite 243 + 25 Nm
Brake disks M6 Loctite 243 + 10 Nm
Clamping screws, upper fork bridge (EXC) M8 20 Nm
Clamping screws, lower fork bridge (EXC) M8 15 Nm
Clamping screws, upper fork bridge (SX) M8 15 Nm
Clamping screws, lower fork bridge (SX) M8 10 Nm
Clamping screws, fork stubs M8 10 Nm
Collar nut, rear wheel spindle M20x1,5 80 Nm
Hexagon nut, swing arm bolt M16x1,5 100 Nm
Hexagon collar screw, handlebar clamp M8 Loctite 243 + 20 Nm
Allan head screw, handlebar support M10 Loctite 243 + 40 Nm
Shock absorber, top M12 80 Nm
Shock absorber, bottom M12 80 Nm
Sprocket screws M8 Loctite 243 + 35 Nm
Ball joint for push rod M6 Loctite 243 + 10 Nm
Engine mounting bolt M10 60 Nm
Engine brace M8 33 Nm
Screw adjusting ring spring preload shock abs.
M6 8 Nm
Spoke nipple M4,5 / M5 5 Nm
Other screws on chassis M6 10 Nm
M8 25 Nm
M10 45 Nm
Other collar nuts on chassis M6 15 Nm
M8 30 Nm
M10 50 Nm
To Next Page
Loading...
