WHEELS, TIRES 14
159
F00863-11
–
Clean the thread of the wheel spindle and screw
2
.
– Clean and grease the wheel spindle.
Long-life grease ( p. 249)
– Position the front wheel and insert the wheel spindle.
The brake linings are correctly positioned.
–
Mount and tighten screw
2
.
Guideline
Screw, front wheel
spindle
M8 25 Nm (18.4 lbf ft)
–
Position wheel speed sensor
3
in the hole.
–
Mount and tighten screw
4
.
Guideline
Screw, wheel speed
sensor holder
M6 8 Nm (5.9 lbf ft)
–
Mount and tighten screws
5
with the washers.
Guideline
Screw, front fender M6 7 Nm (5.2 lbf ft)
– Operate the hand brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point.
– Take the motorcycle off the front lifting gear. ( p. 119)
To Next Page
Loading...
