WORK 7
– Switch off the charger after charging. Disconnect the battery.
Guideline
The charge current, charge voltage and charge time must not be exceeded.
Charge the battery regularly when the
motorcycle is not in use.
3 months
– Mount the seat. ( p. 5)
3.6Installing the battery
500069-11
– Place the battery in the battery holder.
4Ah battery (YTX5L-BS)
– Reconnect the rubber band .
– Attach the plus cable and replace the plus pole cover .
– Attach the minus cable .
– Mount the seat. ( p. 5)
3.7Installing the front fender
500092-10
– Ensure that the spacing sleeves are mounted in the fender.
– Position the front fender. Mount and tighten screws .
Guideline
Remaining screws, chassis M6 10 Nm (7.4 lbf ft)
Info
Take care with the contact between the holding lugs and the start number
plate or headlight mask.
3.8Opening filler cap
400199-10
– Press release button , turn filler cap counterclockwise and lift it free.
3.9Closing filler cap
400199-11
– Replace the filler cap and turn clockwise until the release button locks in place.
Info
Run the fuel tank breather hose without kinks.
To Next Page
Loading...
Need help?
General
