To Next Page

To Previous Page

2 SETUP

F02149-01

– Roll down the film at the sides.

Guideline

To avoid damaging the vehicle while setting it up, do

not remove the protective film on each component until

installing the component, and leave it on the vehicle until

work has been completed.

– Remove the separate enclosure and unpack it. Check that the

scope of supply is complete using the enclosed packing list.

Info

The procedure for missing components is described in

the Customer Service Manual.

– Check the vehicle for transport damage.

Info

The procedure in the event of transport damage is

described in the Customer Service Manual.

F02127-01

– Remove the cable tie. Place the handlebar at the front.

– Remove the clutch and the brake assembly from the transport

holder.

– Remove the screws from the handlebar clamps. Take off the

handlebar clamps and transport holder.

F02128-10

Warning

Danger of accidents A repaired handlebar poses a

safety risk.

If the handlebar is bent or straightened, the mate-

rial becomes fatigued. The handlebar may break as a

result.

– Change the handlebar if the handlebar is damaged

or bent.

– Unpack handlebar and position.

Info

Make sure the cables and wiring are positioned cor-

rectly.

– Position the handlebar clamps. Mount and tighten the screws

evenly.

Guideline

Screw, handlebar

clamp

M8 20 Nm (14.8 lbf ft)

Markings

face backward.

Questions and Answers:

Need help?

Do you have a question about the KTM 890 ADVENTURE R 2021 and is the answer not in the manual?

KTM 890 ADVENTURE R 2021 Specifications

General

Engine Type	2-cylinder, 4-stroke, parallel twin
Displacement	889 cc
Transmission	6-speed
Fuel System	Electronic Fuel Injection
Seat Height	880 mm (34.6 in)
Rear Suspension	WP XPLOR PDS shock absorber
Compression Ratio	13.5:1
Final Drive	Chain
Power	77 kW (105 hp)
Torque	100 Nm
Fuel Tank Capacity	20 liters
Dry Weight	196 kg
Front Suspension	WP XPLOR USD
Front Brake	2 x 320 mm disc, 4-piston radial fixed caliper
Rear Brake	2-piston caliper, brake disc Ø 260 mm
ABS	Bosch 9.1 MP (Cornering ABS and offroad mode)
Frame	Chromium-Molybdenum-Steel frame using the engine as a stressed element, powder coated
Wheelbase	1, 528 mm