Need help?Do you have a question about the KTM 890 Adventure 2021 and is the answer not in the manual?
General| Displacement | 889 cc |
|---|---|
| Bore x Stroke | 90.7 mm x 68.8 mm |
| Transmission | 6-speed |
| Fuel System | Electronic fuel injection |
| Final Drive | Chain |
| Rear Brake | 260 mm disc, 2-piston caliper |
| Dry Weight | 196 kg |
| Tires Front | 90/90-21 |
| Tires Rear | 150/70-18 |
| Ground Clearance | 233 mm |
| Engine Type | Parallel-twin |
| Power | 105 hp (77 kW) @ 8, 000 rpm |
| Torque | 100 Nm |
| Front Suspension | WP APEX 43 |
| Rear Suspension | WP APEX monoshock |
| Front Brake | 2 x 320 mm discs, 4-piston radial calipers |
| ABS | Bosch 9.1 MP (Cornering ABS with Offroad mode) |
| Fuel Tank Capacity | 20 liters |
| Seat Height | 850 mm |
| Wheelbase | 1, 509 mm |
Explains the meaning of various symbols used in the document for clarity.
Explains the typographical formats used in the document for better understanding.
Enabling vehicle electronics from transport mode and locating the diagnostics connector.
Instructions for unpacking the motorcycle and performing initial setup steps.
Steps for removing transport restraints, clamps, and positioning the handlebar.
Checking handlebar position and mounting hand guards.
Mounting brake and clutch assemblies on the handlebar.
Steps for mounting the windshield and its bracket.
Mounting the license plate holder and engine guard components.
Installation of fuel tank covers and initial fixation of the engine guard.
Final tightening of the engine guard and mounting a hose.
Installing starter relay, managing storage, and preparing for vehicle handover.
Detailed steps for adjusting the handlebar position for optimal ergonomics.
Procedures for removing and mounting the passenger seat.
Procedures for removing and mounting the front rider's seat.
Removing and opening the left side cover and storage compartment.
Closing the left storage compartment and installing the left side cover.
Removing and opening the right side cover and storage compartment.
Closing the right storage compartment and installing the right side cover.
Steps for removing and installing the battery cover.
Instructions for charging the 12-V motorcycle battery.
Procedure to safely disconnect the 12-V battery negative cable.
Connecting the battery and checking headlight alignment.
Steps to adjust the headlight beam range.
Guidelines for refueling and operating the fuel tank filler cap safely.
A comprehensive list of torque specifications for various chassis components.
Information and guidelines on using super unleaded fuel and its ethanol content.
To Next Page