KTM 890 ADVENTURE R 2022 User Manual

SETUP 2
3
2.1 Transport mode
H02713-01
This vehicle was blocked for transport in the software.
To operate the vehicle, the vehicle electronics must be enabled.
This process is conducted during initial setup in KTM Dealer.net.
Enabling ensures that the initial setup in KTM Dealer.net is docu-
mented.
Enabling can be performed either temporarily, e.g. for a test ride,
or permanently for vehicle handover.
Info
Make sure that the vehicle is permanently enabled before
handing it over to the customer.
2.2 Diagnostics connector
F01981-10
Diagnostics connector
1
is located under the battery cover.
2.3 Unpacking and setting up the vehicle
F01037-10
– Remove the straps and the box.
F02148-01
– Remove the adhesive tape in the upper area of the motorcycle.

KTM 890 ADVENTURE R 2022 Specifications

General

Engine Type	2-cylinder, 4-stroke, parallel twin
Displacement	889 cc
Transmission	6-speed
Dry Weight	196 kg (432 lbs)
Front Suspension	WP XPLOR-USD, Ø 48 mm
Rear Suspension	WP XPLOR PDS shock absorber
Front Tire	90/90-21
Rear Tire	150/70-18
Fuel System	Electronic Fuel Injection
Compression Ratio	13.5:1
Final Drive	Chain
Traction Control	MTC (Motorcycle Traction Control)
Power	105 hp (77 kW) @ 8, 000 rpm
Torque	100 Nm
Fuel Tank Capacity	20 liters
Seat Height	880 mm
Front Brake	320 mm
Rear Brake	260 mm disc, 2-piston caliper
ABS	Cornering ABS
Wheelbase	1, 528 mm
Ride Modes	Street, Offroad, Rally
Frame	Chromium-Molybdenum-Steel frame using the engine as a stressed element, powder-coated
Ground Clearance	263 mm