EasyManuals Logo
Home>KTM>Motorcycle Accessories>META SYSTEM DEFCOM 3.1B

KTM META SYSTEM DEFCOM 3.1B User Manual

KTM META SYSTEM DEFCOM 3.1B
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
10
KTM | DEFCOM 3.1B User Manual
This is when the alarm system is armed and after the initial immunity phase is over.
Any alarm triggers will produce an alarm cycle that lasts 26 seconds: the direction indicators
ash, the siren emits a distinctive modulated sound, and it will be impossible to start the en-
gine.
7. ACTIVE PHASE
The alarm central unit protects the motorcycle against being started and an alarm cycle will
be triggered every time:
The ignition key is turned ON
An attempt is made to remove or move any part of the motorcycle which is protected
by speci c switches (for example if the seat or the storage compartment is opened...)
The motorcycle is moved
The alarm systems supply cables are disconnected or cut or if the motorcycles battery
is disconnected.
8. PROTECTION BY THE ALARM SYSTEM
Coming back to the vehicle with the CARD B9.5 the alarm unit recognize the Id Tag and turns
o the LED to indicate that is ready to be disarmed turning ON the vehicle instrument panel.
Turning ON the vehicle instrument panel the disarming is signaled by a 1 BEEP sound and 1
ash of the direction indicators.
If the siren also emits a BOOP sound, this means that the alarm system was triggered. To  nd
out how the alarm was triggered, consult the “10. ALARM MEMORY” table.
If visual and acoustic signals are given during arming or disarming that are di erent to those
described above, consult the chapter “11. NOTIFICATION” to  nd out what they mean.
9. DISARMING
If various alarms have been triggered during your absence the ALARM MEMORY will signal
them on the LED emitting a sequences of  ashing with 3 seconds pauses between the sequen-
ces and will repeat the series of sequences every 6 seconds.
The ALARM MEMORY is reset when the alarm system is armed with the CARD B9.5 again or
when the vehicle instrument panel is ON but the alarms memory stay available for 1 minute also
after instrument panel activation.
10. ALARM MEMORY
ALARM MEMORY LED SIGNALS
Internal movement sensor 1 Flash
Contacts 2 Flashes
Ignition key sensing 3 Flashes
Tampering with cables or battery 4 Flashes

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the KTM META SYSTEM DEFCOM 3.1B and is the answer not in the manual?

KTM META SYSTEM DEFCOM 3.1B Specifications

General IconGeneral
BrandKTM
ModelMETA SYSTEM DEFCOM 3.1B
CategoryMotorcycle Accessories
LanguageEnglish

Related product manuals