KTM META SYSTEM DEFCOM 3.1B User Manual

11
KTM | DEFCOM 3.1B User Manual
The DEFCOM 3.1B alarm provides di erent signals (led, siren and  ashing of the vehicle in-
dicators) according to the di erent commands received and di erent conditions which it is,
following are reported the main signals.
11. NOTIFICATIONS
CENTRAL UNIT STATUS
LED
DIRECTION
INDICATORS
SIREN
Arming by CARD B9.5 Slow  ashing 2 Flashes 2 BEEP
Arming without movement
sensor by CARD B9.5
Slow  ashing Flashes 2 + 1 2 BEEP + 1 BEEP
Arming with
active contact
Slow  ashing 2 Flashes 2 BEEP + 1 BOOP
Initial immunity phase Fast  ashing - -
Pre-alarm phase with ignition
key ON or movement sensor
activation
Switches o - 5 BEEP
Alarm cycle (25 sec) Switches o Flashing Sounds
Disarming by CARD B9.5 or
Override Code
Switches o 1 Flash 1 BEEP
Disarming when alarms
have been memorised
Switches o brie y
every 6 sec.
- 1 BEEP + 1 BOOP
Disarming when the
motorcycle’s battery is  at
Switches o - 4 BEEP
CARD B9.5 low battery
warning after disarming
10  ashes after
ignition key ON
--
SERVICE MODE activated
Flashing very fast
with ignition key ON
--
To deactivate the Arming/Disarming Buzzer, it is necessary to contact an installation center
equipped with the PRG007 Programmer or use the smartphone App.
12. BUZZER ARMING/DISARMING DISABLE
If needs excluding the alarm system for a time period, it’s possible enable the SERVICE MODE
modality using its CARD B9.5.
To enable the SERVICE MODE turn ON the motorcycle’s key and immediately after press hold
the CARD B9.5 button at least 6 seconds, the feature enabling is indicated by the LED  ashing
very fast when the motorcycle’s key is ON.
To disable the SERVICE MODE turn ON the motorcycle’s key and immediately after press hold
the CARD B9.5 button at least 6 seconds, the feature disabling is indicated by the LED goes OFF.
13. SERVICE MODE

KTM META SYSTEM DEFCOM 3.1B Specifications

General

Brand	KTM
Model	META SYSTEM DEFCOM 3.1B
Category	Motorcycle Accessories
Language	English