24 SPECIFICATIONS
ENGLISH
SPECIFICATIONS
A Model EBG1 is 1800rpm for 60Hz, EBG2 is 1500rpm for 50Hz.
A Flywheel type is SAE clutch No. 6-1/2 or its equivalent.
A Flywheel housing type is SAE No. 5 or its equivalent.
A Governor drop is within 5%
A Continuous will operate at the stated rating continuously and have a 10% overload capability for one hour in 12
hours.
A Standby will operate at the stated full rating for one hour in 12 hours. No overload capacity is specified for this rating.
A Specifications are subject to change without notice.
A This CO
2
measurement results from testing over a fixed test cycle under laboratory conditions a(n) (parent) engine
representative of the engine type (engine family) and shall not imply or express any guarantee of the performance
of a particular engine.
Model D1005-E3BG1 / D1005-E4BG1
Type Vertical, water-cooled, 4-cycle diesel engine
Number of cylinders 3
Bore and stroke mm (in.) 76 × 73.6 (2.99 × 2.90)
Total displacement cm (cu.in.) 1001 (61.08)
Combustion chamber Spherical Type (E-TVCS)
SAE Continuous kW / rpm
H.P. (SAEJ1349) (HP / rpm)
8.7/1800
(11.7/1800)
SAE Stand-by kW / rpm
H.P. (SAEJ1349) (HP / rpm)
9.8/1800
(13.1/1800)
Maximum bare speed rpm 1890
Order of firing 1-2-3
Direction of rotation Counter-clockwise (viewed from flywheel side)
Injection pump Bosch MD Type Mini Pump
Injection pressure 140 kgf/cm (13.73 MPa, 1991 psi)
Injection timing (Before T.D.C.) 16.5°
Compression ratio 24 : 1
Fuel Diesel Fuel No.2-D (ASTM D975)
Lubricant
(API classification)
above CF grade
Dimension mm (in.)
(length × width × height)
551.3 × 396 × 602
(21.7 × 15.6 × 23.7)
Dry weight
(BB Spec.) kg (lbs.)
110
(242.5)
Starting system Cell starter (with glow plug)
Starting motor 12 V, 1.0 kW
Charging generator 12 V, 360 W
Recommended battery capacity 12 V, 65 AH, equivalent
EU engine family name -
CO
2
Emission data g/kWh
Non-road steady-state test cycle
-
To Next Page
Loading...
