Last digit
of the Code
No.
Month of
Revision
Part name Main revised point and corrective measure
Reference
page
7 2018.12 Mechanism
Servicing
Added the information about all mechanism section.
Added the follow information about checking and adjusting.
• Checking injector
•
Checking suction control valve (SCV)
• Checking sensors
• Adjusting air gap between crank/camshaft position sensor
and flywheel/pulsar gear
Separate disassembling and assembling
Added follow servicing information.
• Replacing injector
• Replacing engine ECU
• Replacing DPF
Change notification about fan drive pulley mounting nut tightening
torque
4-96
4-107
4-107
4-114
4-115
4-191
4-193
4-196
D1803-CR-E4,D1803-CR-TE4,D1803-CR-TIE4,V2403-CR-E4,V2403-CR-TE4,V2403-CR-TE4BG,V2403-CR-TIE4
To Next Page
Loading...
