EasyManuals Logo

Kubota LX2620 User Manual

Kubota LX2620
137 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #117 background imageLoading...
Page #117 background image
5. Properly dispose of used oil.
Oil capacity 15 L (4.0 U.S.gals.)
(1) Oil inlet
(2) Dipstick
(A) Oil level is acceptable within
this range
[LX2620]
(1) Drain plug
(2) Drain plugs
[LX2620SU]
(1) Drain plug
(2) Drain plug (both sides)
IMPORTANT :
If the 3-point hitch cannot be raised by
setting the hydraulic control lever to the UP
position after long term storage or when
changing the transmission oil, turn steering
wheel to the right and left several times to
bleed air from the system.
Do not operate the tractor immediately after
changing the transmission fluid.
Run the engine at medium speed for a few
minutes to prevent damage to the
transmission.
2. Replacing hydraulic oil filter
WARNING
To avoid personal injury or death:
Stop the engine before changing the oil filter
cartridge.
Allow the engine to cool down sufficiently; oil
can be hot and can burn.
1. Remove the drain plugs at the bottom of the
transmission case and drain the oil completely into
the oil pan.
2. After draining reinstall the drain plugs.
[LX2620]
(1) Drain plug
(2) Drain plugs
[LX2620SU]
(1) Drain plug
(2) Drain plug (both sides)
EVERY 400 HOURS  PERIODIC SERVICE
LX2620,LX2620SU
115

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kubota LX2620 and is the answer not in the manual?

Kubota LX2620 Specifications

General IconGeneral
Engine TypeDiesel
Horsepower24.8 hp
Engine Power18.5 kW
PTO Power14.5 kW
Drive4WD
Fuel Tank Capacity6.6 gal (25 l)
Cylinders3
Hydraulic System TypeOpen Center
Three-Point HitchCategory I
PTO TypeIndependent
TransmissionHydrostatic
Transmission TypeHydrostatic
Ground Clearance13.4 in
Turning Radius8.2 ft (with brake)
Weight1, 543 lbs
Wheelbase62.6 in

Related product manuals