2. In
traveling stop status, press the (F) or (R) switch
to move at a fixed speed while the switch is held
down. The speed will also increase if you step on
the foot throttle while traveling.
3. When switching traveling directions, press the (F)
or (R) switch after coming to a complete stop.
4. Step on the clutch pedal to stop.
NOTE :
• Depending on trouble spots, the tractor may fail
to run as expected.
• Park it in a safe place and immediately contact
your local KUBOTA Dealer.
• If you press the (F) or (R) switch by mistake,
turn the key switch off to leave limp home
mode.
Standard, Deluxe model
(1) Limp home switch forward (F)
(2)
Limp home switch reverse (R)
Premium, Premium KVT model
(1) Limp home switch forward (F)
(2)
Limp home switch reverse (R)
CONTINUOUSLY VARIABLE
TRANSMISSION (CVT)
CONTROL
WARNING
T
o avoid personal injury or death:
• The ez-command center has no neutral
position. To bring the tractor to a complete
stop, step on the brake pedal or set the shuttle
lever to neutral.
The continuously variable transmission (CVT) is a fully
computerized stepless type. Depending on the type of
work, there are two modes to choose from: automatic
and manual engine speed setting
Other settings are also possible at will, including CVT
sensitivity in response to engine load, response control
for start and stop, and cruise control among others.
(1) Ez-command center
(2)
Cruise button
(3) Ratio lock button
(4) Mode shift button
(5) Shuttle neutral button
(6) Shuttle enable button
(7) Limp home switch
1. Traveling operation
Traveling speed control for a tractor with CVT can be
operated
with either the ez-command center or the foot
throttle. Choose between them according to the job.
You can control both the speed and the engine power
by how deeply you step on the foot throttle, as with an
automatic transmission car; this enables convenient
operation of the trailer and so on.
NOTE :
• Operating the traveling speed control using the
foot throttle requires the selection of “automatic
mode”.
(See Operation of the automatic mode on page
158.)
OPERATING THE TRACTOR CONTINUOUSLY VARIABLE TRANSMISSION (CVT) CONTROL
To Next Page
Loading...
Need help?
General
