How to fix an uneven cut with my Kubota Lawn Mower?
If your Kubota Lawn Mower is giving an uneven cut, it could be because the mower deck isn't level, you're moving too fast, the blades are dull or worn, the tire inflation is low, or the anti-scalp rollers aren't adjusted correctly. To fix this, level the mower deck, slow down, have the blades sharpened or replaced, add air to the tires, and adjust the anti-scalp rollers.
Why is the belt slipping on my Kubota Lawn Mower?
If the belt is slipping on your Kubota Lawn Mower, it could be due to a plugged mower deck, debris in the pulleys, or a worn belt. Unplug and clean the mower deck, clean the pulleys, or replace the belt.
How to stop excessive vibration in my Kubota RCK60B-23BX?
Excessive vibration in your Kubota Lawn Mower can be caused by debris on the mower deck or in the pulleys, a damaged drive belt or pulleys, pulleys that are out of alignment, or blades that are out of balance. Clean the mower deck and pulleys. Replace the drive belt and pulleys if damaged. Have the blades balanced, and consult your KUBOTA dealer.
Why is my Kubota RCK60B-23BX streaking uncut grass?
If your Kubota Lawn Mower is streaking uncut grass, it might be due to several reasons. You might be moving too fast, or the engine RPM might be too low. The grass could be too long, or the blades could be dull or damaged. Also, check for debris in the mower deck. To address this, try slowing down, mowing at full throttle (and checking/resetting the engine RPM), cutting the grass twice, replacing or sharpening the blades, and cleaning the mower deck.
What to do if the discharge cover of my Kubota RCK60B-23BX Lawn Mower is plugged?
If the discharge cover of your Kubota Lawn Mower is plugged, it could be because the grass is too wet or too long, the cutting height is too low, the engine RPM is too low, or the ground speed is too fast. Wait for the grass to dry. Raise the cutting height, and consider cutting the grass twice. Ensure you're mowing at full throttle and reduce your speed.
Why are the blades scalping grass on my Kubota RCK60B-23BX Lawn Mower?
If your Kubota Lawn Mower blades are scalping grass, it could be due to a cutting height that's too low, turning too fast, ridges in the terrain, rough or uneven terrain, incorrectly adjusted anti-scalp rollers, or bent blades. Raise the cutting height, reduce speed on turns, change your mowing pattern, adjust the anti-scalp rollers, or replace the blades.
What to do if my Kubota RCK60B-23BX Lawn Mower loads down the tractor?
If your Kubota Lawn Mower is loading down the tractor, the engine RPM might be too low, your ground speed might be too fast, or debris might be wrapped around the mower spindles. Mow at full throttle, checking and resetting the engine RPM if needed. Also, slow down and clean the mower.
General| Cutting Width | 60 inches |
|---|---|
| Deck Material | Steel |
| Number of Blades | 3 |
| Drive Type | PTO |
| Required PTO Horsepower | 20 HP |
| Cutting Height Range | 1-4 inches |
To Next Page
