28
4.Veiligheid
4.Veiligheid
CAUTION:
Risks when handling cargo.
Working with the wiellader may entail additional risks. Through the load it is also
possible that driving characteristics and responsiveness of the wiellader is strongly
influenced.
Therefore observe the following precautions:
• The load on the wiellader must not weigh more than indicated in section “Tech-
nical data”. Make sure the load in/on the tool is evenly balanced.
• Move the wiellader with the tool up to 30 cm above the ground.
• Adjust your speed according to road and environmental conditions.
• Make sure you always have full control over the wiellader.
• Reduce your driving speed on rough terrain and sharp turns.
• Be especially careful when manoeuvring and reversing.
• Provide a good overview on the work environment.
• The driver determines the limits for ‘safe working’ with the wiellader.
• Do not take risks. Take care with obstacles, uneven terrain and crowded
areas.
• It is not allowed to transport (multiple) objects or loose cargo that protrudes
above the attachment. The wiellader requires a (FOPS) safety roof or cabin
when using certain attachments. The wiellader can tip over when driving over
uneven or damaged terrain. Moderate your speed.
• There is a risk of injury from involuntary movement due to lack of tension and
braking force of the wiellader.
• Only drive perpendicular to an incline or slope. Do not drive across slopes.
CAUTION:
Danger of technical damage!
Never tilt the attachment bracket when driving
without attachment and with fully retracted lifting
arm. Especially when the wiellader is equipped
with a special attachment bracket (e.g. Euro
bracket). This can severely damage the tyre!
To Next Page
Loading...
Need help?
General
