GENERAL
SM-E4B SERIES, WSM
G-10
Replacing Oil Filter Cartridge
• Be sure to stop the engine before changing filter cartridge.
1. Remove the oil filter cartridge (1) with the filter wrench.
2. Apply a slight coat of oil onto the new cartridge gasket.
3. To install the new cartridge, screw it in by hand. Over tightening
may cause deformation of rubber gasket.
4. After the new cartridge has been replaced, the engine oil
normally decrease a little. Thus see that the engine oil does not
leak through the seal and be sure to read the oil level on the
dipstick. Then, replenish the engine oil up to the specified level.
• To prevent serious damage to the engine, replacement
element must be highly efficient. Use only a KUBOTA
genuine filter or its equivalent.
• The oil pan of 101 mm (3.98 in.) depth is optional for
Z482-E4B and D722-E4B. This service interval is every 150
hours.
9Y1210785GEG0009US0
(1) Engine Oil Filter Cartridge [a] Standard Type
[b] One-side Maintenance Type
To Next Page
Loading...
Need help?
General