EVERY 4 YEARS
1. Replacing hydraulic hose
Consult your local KUBOTA Dealer for this service.
2. Replacing fuel lines
Consult your local KUBOTA Dealer for this service.
SERVICE AS REQUIRED
1. Replacing fuses
1. Raise the operator's seat.
2. Remove the blown fuse.
3. Place a new fuse of the same capacity in position.
IMPORTANT :
• If the new fuse happens to blow out within a
short time, contact your dealer for inspection
and repair. Never “jump” the fuse with wire or
foil, or install a larger capacity fuse than is
recommended.
(1) Fuse box
(2) Slow blow fuse
Protected circuit
Fuse box
Fuse No. Capacity Protected circuit
(1)
5 A Start
5 A Operator control
10 A PTO clutch
15 A Accessories
－ －
－ －
Slow blow fuse
Fuse No. Capacity Protected circuit
(2) 30 A
Check circuit
against wrong
battery connection
2. Checking and replacing blades
WARNING
To avoid serious injury or death:
• Be sure to stop the engine and remove the key.
• Blades may be sharp. When you handle blades,
wear heavy gloves or wrap the end of the
blades with a rag.
Mower deck cleaning
• Before checking or replacing the blades, wipe grass
and mud off the top and inside of the mower.
Especially, clean inside the belt cover, otherwise
the belt life will be reduced.
Checking the blade
The blade cutting edges should be kept sharp at all
times.
1. Sharpen the cutting edges if they look like the blade
(B).
2. Replace the blades if they look like the blade (C).
(A) New blade
(B) Worn blade
(C) Cracked blade
Replacing
1. Dismount the mower deck from the machine.
(See DISMOUNTING THE MOWER DECK on page
22.)
Then turn it over to expose the blades.
2. To prevent the spindle from rotating while removing
the blade bolts, perform one of the next methods:
• Wedge a block of wood between the blade and
mower housing.
• Use a box wrench over the pulley nut.
Then, loosen the blade bolt as illustrated.
PERIODIC SERVICE EVERY 4 YEARS
Z231BR-AU,Z231KH-AU,Z251BR-AU,Z251KH-AU
To Next Page
Loading...
Need help?
General
